|
Gri Commands
1: Introduction 2: Simple example 3: Fancy example 4: Running Gri 5: Programming Gri 6: General Issues 7: X-Y Plots 8: Contour Plots 9: Image Plots 10: Examples 11: Handling Data 12: Gri Commands 13: Gri Extras 14: Evolution of Gri 15: Installing Gri 16: Gri Bugs 17: System Tools 18: Acknowledgments 19: License 20: Newsgroup 21: Concept Index |
12.7: The `
|
`debug [.n.]|[clipped values in draw commands]|off' |
..debug..' to 1.
(Normally, `..debug..' is 0.) You may use `..debug..' in if
statements, etc. Note that `..debug..' is also set to 1 when gri
is invoked with the commandline switch `-d'.
With `.n.' specified, `..debug..' is set to `.n.'; a
value of zero for `.n.' turns debugging off, while 1 turns it on.
Higher values may be used for deeper debugging, if you choose:
if {rpn ..debug.. 2 <}
# Code to do if ..debug.. is greater than 2.
end if
|
..debug..' as you can to any other
variable; `debug .n.' is equivalent to `..debug.. = .n.'.
With the `clipped' option, Gri prints any clipped data encountered
during any `draw ...' commands, EXCEPT in the case of
`postscript' clipping, where no check is possible. (Note that
`..debug..' is not affected.)
All these forms of debugging are cancelled by `debug off'.
