generate.toc — Control generation of ToCs and LoTs
<xsl:param name="generate.toc"> appendix toc,title article/appendix nop article toc,title book toc,title,figure,table,example,equation chapter toc,title part toc,title preface toc,title qandadiv toc qandaset toc reference toc,title sect1 toc sect2 toc sect3 toc sect4 toc sect5 toc section toc set toc,title </xsl:param>
This parameter has a structured value. It is a table of space-delimited path/value pairs. Each path identifies some element in the source document using a restricted subset of XPath (only the implicit child axis, no wildcards, no predicates). Paths can be either relative or absolute.
When processing a particular element, the stylesheets consult this table to determine if a ToC (or LoT(s)) should be generated.
For example, consider the entry:
This indicates that whenever a
book is formatted, a
Table Of Contents and a List of Figures should be generated. Similarly,
indicates that whenever a document that has a root
chapter is formatted, a Table of
Contents should be generated. The entry
chapter would match
all chapters, but
/chapter matches only
Generally, the longest match wins. So, for example, if you want to distinguish articles in books from articles in parts, you could use these two entries:
book/article toc,figure part/article toc
Note that an article in a part can never match a
so if you want nothing to be generated for articles in parts, you can simply leave
that rule out.
If you want to leave the rule in, to make it explicit that you're turning something off, use the value “nop”. For example, the following entry disables ToCs and LoTs for articles:
Do not simply leave the word “article” in the file without a matching value. That'd be just begging the silly little path/value parser to get confused.
Section ToCs are further controlled by the
For a given section level to have a ToC, it must have both an entry in
generate.toc and be within the range enabled by